MicroNet SP918GL Bedienungsanleitung PDF herunterladen (Seite 18)

WLAN Parameter Settings

SSID: (Service Set Identifier): WLAN is the default setting. The SSID is a unique name

that identifies a network. All devices on a network must share the same SSID name to

communicate on the network. If you choose to change the SSID from the default setting,

input a new SSID name in this field. The SSID can be up to 32 characters in length.

SSID Broadcast: Enable will allow all WLAN clients to observe its Wireless LAN

network presence. Disable will make the Access Point invisible to any client scanning.

Frequency: The frequency range will be displayed.

Channel: Channel 6 is the default channel. You may select a different channel, but

remember that all devices on the network must be set to the same channel to

communicate on the network. (Current wireless network adapters will automatically scan

for the channel to establish connection with the access point.)

Data Rate: Select the transmission rate for the network. Auto is the default setting.

Beacon Interval: Beacons are packets sent by an Access Point to synchronize a

wireless network. Specify a Beacon interval value (20-1000.) Default (100) is

recommended.

DTIM: (Delivery Traffic Indication Message) Enter a value between 1 and 255 for the

Delivery Traffic Indication Message (DTIM.) A DTIM is a countdown informing clients of

the next window for listening to broadcast and multicast messages.

Fragment Length: This value should remain at its default setting of 2346. If you

experience a high packet-error rate, you may slightly decrease your Fragment Length

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 34 35

Keine Kommentare

MicroNet SP918GL Bedienungsanleitung Seite 18