MicroNet SP1910 Bedienungsanleitung PDF herunterladen (Seite 32)

On this page, you can configure VPI and VCI values (consult your local ISP if you are not

clear). For other options, keep the defaults and click the “ Apply/Save” button.

2. In Ethernet modes, you are required to configure parameters for Ethernet interface.

To enter the ETH Interface page, click “ Advanced Setup” ---“ Connection Mode”

(Select Ethernet mode and click “ Apply” ) --- “ WAN Service” ---“ ETH Interface” .

And then click the “ Add” button to configure relevant parameters.

The Ethernet interface configured on this page is used as a WAN port. You can select only

one LAN interface to function as a WAN port. Once you finish, click the “ Apply/Save”

button.

4.3.3 WAN service

WAN Configuration in DSL Mode

-PPP over Ethernet (PPPoE)

Click “ Advanced Setup” —“ Connection mode” (Select DSL mode and click

“ Apply” )---“ WAN Service” ---“ ATM Interface” (refer to 4.3 for configuring the ATM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 87 88

Keine Kommentare

MicroNet SP1910 Bedienungsanleitung Seite 32