MicroNet SP5058 Bedienungsanleitung

User's Manual Wireless LAN Bridge Model No.: SP912 World Wide Web: www.micronet.com.tw ; www.micronet.info

-8-Chapter 4 Switch Between Access Point & Bridge This chapter describes the steps to switch from Access Point to Bridge, and Bridge to Acces

-9-4.2 Bridge to Access Point Step1: Enter the default IP address of the Bridge into the address bar of the web-browser (192.168.1.1). Leave the us

-10-Chapter 5 Access Point – Web Configuration 5.1 Logging In To configure the Access Point through the web-browser, enter the IP address of the A

-11-5.2 System The System page is the first page that is displayed after logging in. This page displays information about the Access Point. You ma

-12-5.3 Wireless Click on the Wireless link on the navigation bar in order to configure the wireless settings of Access Point. The page displa

-13-  Access Point name: enter a name for the Access Point.  The SSID: displays the SSID of the Access Point. The SSID is a unique name share

-14-select the default (automatic) to let the Bridge decide which data rate to use.  Preamble Type: select a preamble type from the drop-down li

-15- Multicast PM buffering: enabling this function can avoid network congestion when there are too many clients to transmit data simultaneously.

-16-5.5 Admin Click on the Admin link on the navigation bar in order to configure the user name and password to log into the device. You may also

-17- Administrator password: type in the new password into this field, and re-enter it for confirmation purposes in the field below.  Isolatio

Table of Contents Chapter 1 Introduction...

-18-Chapter 6 Bridge Mode – Web Configuration 6.1 Logging In To configure the Bridge through the web-browser, enter the IP address of the Bridge i

-19-6.2 System The System page is the first page that is displayed after logging in. This page displays information about the AP and Bridge. You ma

-20- Results of the most recent scan: these are the results of a site survey and display the SSID, MAC address, channel number, signal strength, a

-21-among all points in your wireless network. The SSID must be identical for all points in the network, and is case-sensitive. Leaving this field b

-22-6.5 Admin Click on the Admin link on the navigation bar in order to configure the threshold values and login details. You may also reboot this

-23- Default subnet mask: enter the subnet mask for this Bridge.  Default Gateway: enter the IP address of the default gateway.  Device Name:

-24-Appendix A Specifications Model SP912 Standard IEEE 802.11b compliant LAN Port One 10Base-T RJ-45 LAN Port Radio Modulation DSSS Frequen

-1-Chapter 1 Introduction Thank you for purchasing Micronet Wireless LAN Bridge SP912. It operates seamlessly in the 2.4 GHz frequency spectrum s

-2-1.2 Package Contents Open the package carefully, and make sure that none of the items listed below are missing. Do not discard the packing mater

-3-Wireless extensions to Ethernet networks Network managers in dynamic environments can minimize the overhead caused by moves, extensions to networ

-4-Infrastructure Mode The infrastructure mode requires the use of an access point (AP). In this mode, all wireless communication between two comput

-5-Chapter 2 Hardware 2.1 Hardware Configuration  RJ-45 Ethernet Connector – Provides 10 Mbps connectivity to a wired Ethernet LAN.  Reset Bu

-6-Chapter 3 Configuration Follow the steps below in order to configure the TCP/IP settings of your PC. A. In the Control Panel double click Net

-7- C. Select Use the following IP address radio button, and then enter an IP address and subnet mask for your PC. Make sure that the device and