MicroNet SP5058 Bedienungsanleitung PDF herunterladen (Seite 25)

-23-

 Default subnet mask: enter the subnet mask for this Bridge.

 Default Gateway: enter the IP address of the default gateway.

 Device Name: enter a name for this Bridge. This field is optional.

 Allow upgrade uploads: this Bridge can be upgraded via TFTP, therefore place a check

in this box if you would like to upgrade this device. It is recommended that this box is

unchecked during normal operation, when it does not need to be upgraded.

 Cloning bridge: place a check in this box to use MAC cloning. The Bridge will set the

wireless interface to use the MAC address of a device from the wired side. Multiple

devices can be connected but only the first device will be cloned.

 Fragmentation threshold: transmitted wireless packets larger than this size will be

fragmented to maintain performance in noisy wireless networks.

 RTS threshold: transmitted wireless packets larger than this size will use the

RTS/CTS protocol to (a) maintain performance in noisy wireless networks and (b)

prevent hidden nodes from degrading performance.

 User name: this user name is used in order to log into the Bridge. If you would like to

change the existing user name, enter it into this field.

 Administrator password: type in the new password into this field, and re-enter it for

confirmation purposes in the field below.

 Click on the Save button to confirm the changes. You must reboot the Bridge in order

for these new settings to take affect.

 Reset to factory defaults: click on this button to reset the Bridge to its factory default

settings.

 Switch to AP: click on this button to switch to Access Point mode.

1 2 ... 20 21 22 23 24 25 26

Keine Kommentare

MicroNet SP5058 Bedienungsanleitung Seite 25